12/19/2023 0 Comments Hexagon autocadSelect the Fillet command and apply a fillet of radius 3 on the upper and lower edge of the outer circle.Select the Extrude command Now, again draw the figure shown in step 3:.Draw the circle of radius 0.6 anywhere on display Select the Helix command Select the Intersect command and select both the created solids Select the Fillet command and apply a fillet of radius 3 on the upper and lower edge of the outer circle, as shown below:.Extrude the outer circle with a height of 20.Select the Subtract command and subtract circle from the hexagon, as shown below:.Select the Extrude Now, extrude the inner circle and hexagon with a height of 20.Draw a circle circumscribing the hexagon of radius 20, as shown below:.The center points of hexagon and circle are the same. The steps to create the above figure are listed below: Here, we will create a Nut and Bolt in AutoCAD 3D.īelow is the object: Note: It would be best if you first tried creating the above figure by yourself Next → ← prev Practice Question A Nut and Bolt
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |